From a recent parts acquisition, we had a brand new set
of Andrews 2X cams for this engine. They have not been made for years,
but are excellent street cams that require no cylinder head modification
such as grinding to clear the lobes. Once installed, these cams are "degreed".....adjusted
to open and close the valves at specific points in relation to crankshaft
position. This procedure allows the engine builder to fine tune and adjust
the point where peak horsepower will occur. This is essential in the installation
of any non-stock cams in any engine, and can also greatly improve an engine's
performance even if stock cams are used. Andrews 2X cams call for a "lobe
center angle" of 106 degrees - the valves will be at their maximum lift
106 degrees from TDC.
For pics of the finished engine Click
here!
For the previous Kaw engine page Click
here
E-Mail s at > jim@redlinecycle.com
E-Mail Redline Cycle
Return to Home Page
